- Joined
- Jan 3, 2014
- Messages
- 16,501
- Reaction score
- 3,829
- Location
- Sheffield
- Gender
- Male
- Political Leaning
- Other
I have an idea for a new type of pipe clip. It's not much, not rocket science, but it would make my job a little easier and I think it could be slightly cheaper to make than the ones I use today.
It's just a piece of 8mm bar with a thread on either end, a couple of bends and then zinc coated.
I have been told that the price to get it made here in the UK is above the 16p price of the present system and that I could probably get it done in the third world.
How do I contact such manufacturers?
It's just a piece of 8mm bar with a thread on either end, a couple of bends and then zinc coated.
I have been told that the price to get it made here in the UK is above the 16p price of the present system and that I could probably get it done in the third world.
How do I contact such manufacturers?